EN-14
CARE AND MAINTENANCE 1
• To maintain optimum performance of this air purier, please clean the
product including the lter periodically.
• Be sure to stop operation and unplug the product before any maintenance
or replacing accessories.
Gently remove dust from the back panel, using a
vacuum cleaner attachment or similar tool.
Back Panel
Back Panel
MAIN UNIT
Wipe with a dry, soft cloth.
For stubborn stains or dirt, use a soft cloth dampened with warm water.
• Do not use volatile uids.
Benzine, paint thinner, polishing powder, etc. , may damage the surface.
• Do not use detergents.
Detergent ingredients may damage the main unit.
1. Add a small amount of dish detergent to water and
soak for about 10 minutes.
2. Rinse o the dish detergent with clean water.
3. Completely dry the lter in a well-ventilated area.
How to clean hard to remove dirt
NOTE
Be careful not to apply too much force to the pre-lter.
FILTER MAINTENANCE SIGN
MAINTENANCE
NOTE
NOTE
The FILTER MAINTENANCE
SIGN changes from red to
green.
The FILTER MAINTENANCE SIGN will turn red* when it is time to maintain the back panel
(pre-lter) .
*This sign will turn red after approximately 720 hours operating. (30 days × 24 hours = 720 hours)
After maintenance, connect the power plug to the wall outlet and press POWER ON/OFF
button, then PLASMACLUSTER EXPRESS CLEAN button for 3 seconds.
FILTER
MAINTENANCE SIGN
more
3 sec.
BACK PANEL
(Pre-lter)
When the FILTER
MAINTENANCE SIGN turns red.
OM_FP-K50U_EN.indd 14 2019/09/05 10:14:40
To Next Page
Loading...
Need help?
General
