Sharp FP-S42

EN-2
areas, etc.)
7. Keep the room well ventilated when
using the product around appliances that
produce combustion (gas appliances,
etc.). Otherwise it may cause carbon
monoxide poisoning.
8. Do not allow the product to get wet.
9. Do not insert fingers or foreign objects
into the Air Inlet or Air Outlet openings.
10. Do not place anything on the Air Outlet.
11. Do not look into the Air Outlets.
12. Do not sit on, lean on or tilt the product.
CAUTIONS
PRECAUTIONS DURING
INSTALLATION
1. Place the product upright on a level
and stable surface with sufficient air
circulation.
2. Do not place the product on unstable
surfaces. (Beds, sofas, heavy carpets,
etc.) Doing so may cause the product to
tip over.
3. If used for a prolonged period of time, the
area around the product may become
dirty, so please clean the surrounding
walls, floors and rugs regularly.
If you are concerned about dirt, move
the product away from any surrounding
objects.
4. Do not block the Air Inlets or Air Outlets.
Be careful not to block them with
furniture, curtains, etc.
5. Use under appropriate conditions
between 0ºC – 35ºC.
6. Do not place the product in the following
locations. Doing so may cause the
product to deform, crack, discolor, or
break the sensor.
a. Outdoors or in direct sunlight.
b. Locations subject to drastic
temperature changes.
c. Locations where the product would be
exposed to direct wind or drafts.
PRECAUTIONS DURING
OPERATION
1. Do not operate the product without the
filters properly installed.
2. Always lift the product up when moving
it over easily damaged flooring, uneven
surfaces, or carpets.
3. When carrying the product, remove the
AC Adapter from the product and then
hold the Handles on both sides of the
product.
4. Do not operate the product in a room
where aerosol insecticides are present
.
As this may cause any insecticide fumes
to remain in the product and be emitted
from the Air Outlet.
5. Do not use products containing
fluororesin or silicone (cosmetics, hair
care products, etc.,) near this product.
The fluororesin or silicone could get
stuck inside this product, and cause
Plasmacluster Ions cannot be generated.
NOTE
Interference with radio or television,
etc.
If the product causes interference with
the reception of radio, television or radio-
controlled clocks, then increase the distance
between the product and the device in
question.
FP-S42_40.indb 2FP-S42_40.indb 2 2024/03/15 10:12:572024/03/15 10:12:57