Sharp HT-CN300H - Basic Operation; Setting the System Clock

22
HT-CN300H_(E)4.fm02/6/17
HT-CN300H
Basic Operation
- Setting the clock -
Setting the clock
By setting the unit on time, you can use it both as a clock and as a timer.
In this example, the clock is set for the 24-hour (0:00) display.
Note:
The "CLOCK" or time will flash at the push of the CLOCK button when the AC power
supply is restored after a power failure or unplugging the unit.
Readjust the clock.
To readjust the clock:
Perform "Setting the clock" from step 1. If the time display is flashing, step 3 (for
selecting the 24-hour or 12-hour display) will be skipped.
To change the 24-hour or 12-hour display:
Note:
Setting the clock cancels the demonstration mode automatically.
1
Press the ON/ (STAND-BY) button to turn the power on.
2
Press the CLOCK button and within 5 seconds, press the ENTER
button.
3
Press the or button to select the 24-hour or 12-hour display and
then press the ENTER button.
Note that this can only be set when the unit is first installed or it has been reset (see
page 41).
"0:00" The 24-hour display will appear. (0:00 - 23:59)
"AM 12:00" The 12-hour display will appear. (AM 12:00 - PM 11:59)
"AM 0:00" The 12-hour display will appear. (AM 0:00 - PM 11:59)
4
Press the or button to adjust the hour and then press the EN-
TER button.
z
Press the or button once to advance the time by 1 hour. Hold it down to
advance continuously.
z
When the 12-hour display is selected, "AM" will change automatically to "PM".
5
Press the or button to adjust the minutes and then press the
ENTER button.
z
Press the or button once to advance the time by 1 minute. Hold it down
to change the time in 5-minute intervals.
z
The hour will not advance even if minutes advance from "59" to "00".
z
The clock starts from "0" second. (Seconds are not displayed.)
To confirm the time display:
Press the CLOCK button.
The time display will appear for about 5 seconds.
When the unit is set to DVD or VIDEO, the time also ap-
pears on the TV screen.
1 Clear all the programmed contents. [Refer to "Clearing all the memory (reset)" on
page 41 for details.]
2 Perform "Setting the clock" from the beginning.