Sharp HT-CN300H - Storing and Recalling Radio Stations

28
HT-CN300H_(E)4.fm02/6/17
HT-CN300H
Basic Operation
- Listening to a memorised station -
Listening to a memorised station

Memorising a station
You can store 40 AM and FM stations in memory and recall them at the push of a but-
ton. (Preset tuning)
Note:
The backup function protects the memorised stations for a few hours should there be
a power failure or the AC power lead disconnection.

To recall a memorised station

To scan the preset stations
The stations saved in memory can be scanned automatically. (Preset memory scan)

To erase entire preset memory
1
Perform steps 1 - 3 in "Listening to the radio" on page 27.
2
Press the MEMORY button to enter the preset tuning saving mode.
3
Within 30 seconds, press the or button to select the preset
channel number.
z
Store the stations in memory, in order, starting with preset channel 1.
z
When " " is displayed, a station has already been stored in memory.
4
Within 30 seconds, press the MEMORY button to store that station
in memory.
If the "MEMORY" and preset number indicators go out before the station is mem-
orised, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a preset sta-
tion.
When a new station is stored in memory, the station previously memorised will
be erased.
Press the or button to select the desired station.
Preset channel Frequency and frequency band
1
Press the or button for more than 0.5 seconds.
The preset number will flash and the programmed stations will be tuned in se-
quentially, for 5 seconds each.
2
Press the or button again when the desired station is located.
1 Press the TUNER/BAND button.
2 Hold the CLEAR button down for 3 seconds or more.
3 Whilst "CLEAR" is flashing, press the ENTER button.