Sharp HT-CN300H - Tuning and Receiving Radio Stations

27
HT-CN300H_(E)4.fm02/6/17
HT-CN300H
Basic Operation
- Listening to the radio -
Listening to the radio
To receive an FM stereo transmission:
Press the TUNER/BAND button to display the "ST" indicator.
z
" " will appear when an FM broadcast is in stereo.
z
If the FM reception is weak, press the TUNER/BAND button to extinguish the "ST"
indicator. The reception changes to monaural, and the sound becomes clearer.
After use:
Press the ON/ (STAND-BY) button to enter the power stand-by mode.
1
Press the ON/ (STAND-BY) button to turn the power on.
2
Press the TUNER/BAND button repeatedly to select the desired
frequency band (FM ST, FM or AM).
3
Press the or button to tune in to the desired station.
Manual tuning:
Press the or button as many times as required to tune in to the desired sta-
tion.
Auto tuning:
When the or button is pressed for more than 0.5 seconds, scanning will start
automatically and the tuner will stop at the first receivable broadcast station.
Notes:
z
When radio interference occurs, auto scan tuning may stop automatically at
that point.
z
Auto scan tuning will skip weak signal stations.
z
To stop auto tuning, press the or button again.
z
When an RDS (Radio Data System) station is tuned in, the frequency will be
displayed first, and then the RDS indicator will light. Finally, the station name
will appear.
z
Full auto tuning can be achieved for RDS stations "ASPM", see page 31.
FM stereo mode indicator
FM stereo receiving indicator