Sharp HT-CN300H - Sleep Timer Functionality

39
HT-CN300H_(E)4.fm02/6/17
HT-CN300H
Advanced Features
- Timer and sleep operation -
When the preset time is reached:
z
Playback starts automatically and the volume increases gradually.
z
The unit will enter the power stand-by mode one hour after the timer playback
starts.
To reset or change the timer setting:
Perform "Setting the timer" from the beginning (page 38).
Cancelling the timer playback:
Timer is cancelled by turning the power on whilst in the timer stand-by mode.
Notes:
z
Once the time is set, the setting will be retained until a new time is entered.
z
The contents of the setting will be erased if the unit is unplugged or a power failure
occurs. In such cases, set the timer again.
z
You can select the other source in step 2 of "Setting the timer", but this unit cannot
set the timer of other equipment.
z
When in the timer stand-by mode, the X-BASS button does not allow you to enter
the demonstration mode.

Setting the sleep timer
You can set the unit to the power stand-by mode at the specified time.
Note:
You can select the other source in step 1 of "Setting the sleep timer", but this unit
cannot set the sleep timer of other equipment.
To confirm the remaining sleep time:
Press the TIMER/SLEEP button.
z
The remaining sleep time is displayed for about 5 seconds.
z
You can change the remaining sleep time whilst it is displayed by pressing the
ENTER button (steps 3 - 4).
To cancel the sleep operation:
Press the ON/ (STAND-BY) button whilst the sleep timer is set.
To cancel the sleep timer without setting the unit to the stand-by mode, proceed as
follows.
1
Press the TUNER/BAND button.
Tune in to the desired station. (See page 27.)
2
Press the TIMER/SLEEP button repeatedly until "SLEEP" is dis-
played.
3
Press the or button to change the sleep time.
(Maximum: 3 hours/Minimum: 1 minute)
z
3 hours - 5 minutes 5-minute intervals
z
5 minutes - 1 minute 1-minute intervals
4
Press the ENTER button.
The sleep timer indicator lights up.
5
Your system will enter the power stand-by mode automatically af-
ter the preset time has elapsed.
The volume will be turned down 1 minute before the sleep operation finishes.
At that time, you cannot change the volume.
1 Press the TIMER/SLEEP button.
2 Within 5 seconds, press the ENTER button.
3 Press the or button to select "SLEEP0:00", and press the ENTER button.