Sharp IG-DL1Y

ENGLISH
E-5
Installation using the clamp
①
②
Attach the clamp. (See the instructions below.)
Ensure that the connecting part is inserted all the way in the
insertion section of the clamp.
Note:
To remove the unit from the stand, press and hold the both (right and left) installing tabs and lift.
Ensure that the fi xing tabs of the connecting part are inserted and lock in the clamp.
(You can hear a clicking sound.)
Avoid installations shown below.
There are two ways of installation using the clamp. It can be set to vertical or horizontal.
<Vertical installation of the clamp> <Horizontal installation of the clamp>
Connecting
part
Installing
section
25 - 50
mm
Clamp
Insertion
section
Clamp fi xing handle
Insert
Connecting
part
Installing
section
25 - 50
mm
Clamp
Insertion
section
Clamp fi xing
handle
Insert
Clamping
allowance is
insuffi cient
Board is
too thin
Board is
too thick
Round
pipe
Installation
from the
under side
Uneven
place
Installation in which the
connecting part is facing
sideways
Connecting part
(To the backrest of the
bed etc.)
(To the side table etc.)
IG-DL1Yen.inddSec1:5IG-DL1Yen.inddSec1:5 2011/09/309:21:012011/09/309:21:01