Sharp IG-ETC1A

E-1
IG-ETC1A/E
ENGLISH
Hong Kong/
ASEAN
( )
ENGLISH
CONTENTS
IMPORTANT SAFETY INSTRUCTIONS
...............................
E-2
• WARNING
.....................................................................................
E-2
• CAUTIONS CONCERNING OPERATION
....................................
E-3
PARTS NAME
.............................................................................. E-4
• Control panel / Display / Remote control
......................................
E-4
• Main unit / Accessories
.................................................................
E-5
PREPARATION
...........................................................................
E-6
OPERATION
................................................................................
E-8
CARE AND CLEANING
..........................................................
E-13
• Main unit
.....................................................................................
E-13
• Filter
............................................................................................
E-13
• Inside of Air trunk
........................................................................
E-14
• Plasmacluster Ion Generating Unit
.............................................
E-16
PLASMACLUSTER ION GENERATING UNIT REPLACEMENT
...
E-17
HOW TO REPLACE THE PLASMACLUSTER ION GENERATING UNIT
...
E-18
SPECIFICATIONS
....................................................................
E-18
TROUBLESHOOTING
.............................................................
E-19
Thank you for purchasing this SHARP Plasmacluster Ion Generator.
Please read this manual carefully before using Plasmacluster Ion Generator.
After reading, keep the manual in a convenient location for future reference.
The information provided in this manual is subject to change without notice.
• While IG-ETC1A/IG-ETC1E can remove suspended viruses and other
contaminants, it cannot create a completely sterile environment. SHARP
does not guarantee its ability to prevent microbial infection.
• To enable stable emission of high-density Plasmacluster ions, the
Plasmacluster Ion Generating Unit mounted in IG-ETC1A/IG-ETC1E will
need to be replaced periodically*.
* Replacement is required approximately every 2 years (17,500 hours) when operated 24
hours a day. Plasmacluster Ion Generating Unit will stop operating after about 26 months
(19,000 hours).
IG-ETC1Een.inddSec1:12012/09/2716:45:52