E-19
IG-ETC1A/E
ENGLISH
Hong Kong/
ASEAN
( )
Problem WHAT TO DO
[ For Main unit ]
The Plasmacluster Ion Generator
does not work.
• Is a AC Adapter inserted properly?
Please insert AC Adapter correctly.
• It takes approx. 2 seconds for power distribution after the
plug is inserted in the outlet.
Unit Replacing Light
is ß ashing (red).
• It is over the usage period of main unit. Replace with new
Plasmacluster Ion Generating Unit. (See E-17)
• If the replacement period of the unit is passed, the Unit
Replacing Light (red) flashes rapidly and the operation is
stopped. (See E-17)
Filter Clean Light is
lighting (orange).
• Clean the Þ lter. (See E-9)
• Press the Filter Reset Button for at least 3 seconds.
(See E-9)
Is this product equipped with OFF
timer and ON timer functions?
• If you press the Timer Button (main unit / remote control)
during the operation, "OFF Timer" is set.
If you press the Timer Button (main unit / remote control)
while the operation is stopped, "ON Timer" is set.
• ON Timer and OFF Timer cannot be set at the same time.
The discharged air has odor. • The Plasmacluster Ion Generator releases a small trace of
ozone which may produce odor.
This is not detrimental to health.
A discontinuous noise is heard.
A clicking or ticking sound
comes from the unit.
The air ß ow decreases.
• Clicking or ticking sound may be audible when the unit is
generating ions. (The interval of sound may change.)
You may feel the sound becomes large or small depending
on use environment or operation mode, but it will not be
affected the effectiveness of Plasmacluster ion.
• Dust may block the Þ lter, clean the Þ lter. (See E-13)
After cleaning the Þ lter, press the Filter Reset Button for at
least 3 seconds.
TROUBLESHOOTING
Before calling for service, please review the TROUBLESHOOTING chart below.
The problem may not be unit malfunctions.
Flashing
(red)
Lighting
(orange)
UNIT
(Press 3sec.
To Next Page
Loading...
Need help?
General
