E-20
Problem WHAT TO DO
[ Error indication ]
• Plasmacluster Ions are not released.
Clean the electrode section of the unit. (See E-16)
• Is the Plasmacluster Ion Generating Unit installed correctly?
Remove the unit, fully inserted again and press the
Operation Button. (See E-16)
• Is an air suction port cover inserted properly?
Insert air suction port cover correctly, and press the
Operation Button. (See E-13,15)
• Pull out the AC adapter and insert it again in approx. 1
minute, and then operate the product again.
• If an error is displayed repeatedly, please contact the store
you purchased the product or Sharp Service Centre.
TROUBLESHOOTING
Before calling for service, please review the TROUBLESHOOTING chart below.
The problem may not be unit malfunctions.
IG-ETC1Een.inddSec1:202012/09/2416:33:51
To Previous Page
Loading...
Need help?
General
