E-6
1
2
3
Remove a cover on the rear side of the remote
control.
Set batteries following
and indications
properly.
Attach the cover.
•
Point the remote control towards the receiver window and press
the desired button for operation.
• It may not be controlled if the pointing direction is out of
range, or something is blocking the distance to the signal
receiver window.
•
Do not drop or throw the remote control.
Do not wet the remote control.
Set batteries in the remote control (Replacement of batteries)
Operation of the remote control
Note:
• When batteries are low, the operation range of the remote control may become narrow.
• The signal may be interfered with when under certain ß uorescent lamps or in direct sunlight.
• Incorrect usage of batteries could cause the product to corrode with a liquid leakage or explosion
of the batteries.
• Do not recharge, disassemble or heat it up.
• When replacing the batteries, always change both and use the same type.
• If the product is not used for a long time, remove the batteries from the remote control. (to avoid
damage by liquid leakage)
• If the liquid in a battery leaks and enters your eye, or contacts your skin or clothes, wash with
sufÞ cient clean water immediately.
Receiver window
PREPARATION
Cover
(AAA dry-cell battery DC1.5V x2)
Approx. 3m or less
IG-ETC1Een.inddSec1:62012/09/2416:33:38
To Next Page
Loading...
Need help?
General
