E-9
IG-ETC1A/E
ENGLISH
Hong Kong/
ASEAN
( )
Adjust the vertical swing angle
1
1
2
Power OFF
Memory function
POWER
POWER
Main unit
Main unit
Remote control
Remote control
Press the Vertical Swing Button.
Press the Vertical Swing Button to
stop the swing when the louver comes
to your favorite position.
• Every time when you press the Vertical Swing
Button, the louver operation switches to "ON"
or "OFF".
• The vertical swing starts at 40 degrees upward.
• The operation stops after all lights go out and
the louver blocks the outlet port.
Beep
Beep
Beep
Note:
• Do not move the louver with your hands.
• Do not touch the moving louver.
Beep
If the operation is stopped by the Operation Button on the main unit or the remote control,
the operation status of Cool Wind Ion Mode and Sensor Mode is memorized.
• The settings of Timer, Room Cleaning Mode and Clothes Deodorizing Mode are not memorized.
• After electric power failure or AC adapter is pulled out, the memorized content is deleted.
(Excluding the case when the operation automatic recovery function is set) (See E-12)
Note:
• With this product, horizontal / vertical swing angle cannot be adjusted manually.
Be sure to adjust them with main unit or remote control.
• The operation may temporarily stop when the operation range becomes the maximum during swing
or louver operation, however, it is not a troubleshooting.
• If the swing does not operate in 2 seconds or more after vertical or horizontal swing is turned ON,
pull out the AC adapter from an outlet immediately and contact the distributor you purchased the
product.
Press the Operation Button.
(When the vertical swing operation OFF)
IG-ETC1Een.inddSec1:92012/09/2416:33:40
To Next Page
Loading...
Need help?
General
