67
LC-32LB370U/LC-50LB370U Sharp 32"/50" LED TV
Remote control
General
Poor picture.
• Make sure that the room is not
too bright. Light reflecting off the
screen can make the picture
difficult to see.
•If an S-VHS camera or a
camcorder is connected while
another connected device is
turned on, the picture may be
poor. Turn off one or more
devices.
Good sound, but
poor color.
• Adjust the contrast, color, and
brightness settings. See
“Adjusting the TV picture” on
page 44.
Audio noise.
• Other devices (for example, a
surround sound receiver, external
speakers, fans, or hair dryers) may
be interfering with your TV. Try
turning off one device at a time to
determine which device is
causing interference. After you
have determined which device is
causing interference, move it
further from the TV to eliminate
the interference.
No output from
one of the
speakers.
• Adjust the audio balance. See
“Adjusting sound settings” on
page 46.
• Make sure that the audio cables
are connected correctly and
securely to your TV.
After images
appear.
• Do not display a still image, such
as a logo, game, or computer
image, for an extended period of
time. This can cause a permanent
after-image to be burned into the
screen. This type of damage is not
covered by your warranty.
Problem Solution
Problem Solution
Remote
control does
not work.
• Make sure that the power cord is
correctly connected to your TV and
a power outlet.
• Make sure that there are no
obstructions between the remote
control and the remote control
sensor on the front of the TV.
• Point the remote control directly at
the remote control sensor on your
TV. For the location of the remote
control sensor, see “Front” on
page 9.
• The supplied batteries are wrapped
tightly in clear plastic. Make sure
that you have removed this plastic
from the batteries.
• Make sure that the batteries are
installed correctly. See “Installing
remote control batteries” on
page 32.
• Replace dead batteries with new
batteries. See “Installing remote
control batteries” on page 32.
Problem Solution
No power.
• Make sure that the power cord is
correctly connected to your TV
and a power outlet.
• Unplug the power cord, wait 60
seconds, then plug the cord back
in and turn on your TV.
• Other devices (for example, a
surround sound receiver, external
speakers, fans, or hair dryers) may
be interfering with your TV. Try
turning off one device at a time to
determine which device is
causing interference. After you
have determined which device is
causing interference, move it
further from the TV to eliminate
the interference.
“No signal”
error message is
displayed.
• Press INPUT and make sure that
you have selected the correct
input for the device or service you
are trying to use.
• If you are using a cable or satellite
box, use the remote that came
with that box to change channels.
• Make sure that you have the
correct input selected to view
channels from the cable or
satellite box.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
