On=Screen Display Menu
Example Example
®
®
®
T_he bar above is an operational guide for
[ acc°_ the redmaOtceeCOit_laThenbaruW_llettihngnsgce ienen' 1
(_ Press 4/1_ to enter the desired item or return to
the upper level menu.
(9 Press A/T to select the desired item.
(_ Press 4/1_ to adjust the item.
(_ Item displayed in yellow
• This indicates the item currently selected.
Press I_ to go to the adjustment screen for this
item.
(9 Item displayed in blue
This indicates that the item can be selected.
(3_ Item displayed in gray
This indicates that the item cannot be selected.
Thereare variousreasonswhy the itemscannot be
selected, but the main reasonsare as follows:
-- Nothing isconnected to the selectedinput
terminal.
-- The function is not compatiblewith the current
input signal.
Menu options differ in the selected input modes, but
the operating procedures are the same.
Using the remote control
Use the following buttons on the remote control to
operate the menu.
DISpLAy MENU/EXiT '( _ _" _Vlove
MENU/EXIT: Press to open or close the menu screen.
A/T/4/I_: Press to select a desired item on the
screen or adjust a selected item,
SELECT: Press to go to the next step or complete
the setting.
Using the control panel of the main unit
You can also operate the menu with the control panel
of the main unit.
Button operations on the control panel correspond to
the ones on the remote control as shown below.
CH
[].
MENU
INPU_
[]
¢
VOL +/-: Cursor t_/4 on the remote
control.
CH A/T: Cursor A/T on the remote control.
MENU: MENU on the remote control or
Select on the remote control while OSD
menu is on.
INPUT: SOURCE on the remote control.
(D- 20
To Next Page
Loading...
Need help?
General