2008-03-14
LC-42SB45U
5
[2] OPERATION MANUAL
Remote control unit
POWER: Press to turn on/off the TV from on to standby mode, or inversely
DISPLAY: Press to display information about the selected TV channel (Channel
banner)
INPUT: 1. Press repeatedly to select the signal source:
2. The Input List should be activated and show on OSD.
MUTE : Interrupt the sound or restore it.
Number Key: 1. Press number button to direct access to TV channel
2. Press the pass code to activate the factory mode
3. Press to activate the Channel Lock (enter PIN code for Channel lock)
4. If channel list OSD active – jump to that channel in the channel list
(not tune the channel until OK is pressed)
- Dot key: Used for the digital channels
ENT: Used for accepting the key-in channel number
VOL +/ -: Press to adjust the volume
CH +/ - : 1. Press to browse channels
2. Press to turn on TV from stand by mode
3. The channel number should appear on the set
FREEZE : Frozen the current display
SURROUND : change audio mode (Mono/Stereo/Surround)
PLASHBACK: Press to alternate between the currently viewed program and previously
viewed program (It should return to previous view if it comes from
different signal source)
SLEEP: Press to show the sleep-timer slider in the right side of screen. Press
displays current, subsequent presses advance (Loops)
MENU: Press to activate OSD menu or exit OSD
To Next Page
Loading...
Need help?
General