2008-03-14
LC-42SB45U
7
Preparation
Supplied accessories
Note：
1．Always use the AC cord supplied with the TV.
2. AC cord enclosed in this product is for 110-125V.In using it on the 125-240V AC,pls consult the
following:
SHARP ELECTRONICS CORPORATION,LATIN AMERICA GROUP 6100 BLUE LAGOON
DRIVE,SUITE 150,MIAMI,FLORIDA 33126,U.S.A
Attaching/Detaching the TV Stand
1. Confirm that there are 4 screws supplied with the stand unit
2. ○
1
Insert the stand into the openings on the buttom of the TV
○
2.
2Insert and tighten the 4 screws into the 4 holes on the
buttom of the TV.
Note:
To detach the stand,perform the steps in reverse order
Detaching the stand neck for Wall mounting
1. ○
1
Loosen the 4 screws that secure the stand neck by using
a cross-head screwdriver
○
2
Remove stand neck from the TV set.
2. Loosen the 4 screws and pull out hinge plate
3. ○
1
Place the hinge plate in the TV set as illustration shown
○
2
Place the stand cover in the TV set and tighten the 4 screws
Into the 4 holes
To Next Page
Loading...
Need help?
General