Channel Settings
Auto Installation
Basic adjustment
Auto Installation
Setup
The TV automatically detects and stores all available
services in your area. This function also allows you to
perform the channel setting for digital, satellite and
analogue individually and reconfigure the settings after
the initial auto installation has been completed.
Press c/d to select “Yes”, and then press OK.
Press a/b/c/d to select the desired
language, and then press OK.
You cannot set the Home/Store setting and the country
setting in “Auto Installation” in the “Setup” menu. If you want
to reconfigure those settings, automatically execute initial auto
installation after executing “Reset” from the “Setup” menu.
The current country setting is displayed on the screen.
Press a/b to select the broadcast standard
you want to search, and then press OK.
Digital Search
After selecting the service you want to search,
either “Terrestrial” or “Cable”, refer to “Digital
Search” setting on pages 11–13.
NOTE
The “Digital Search” has a “Reset” function. This function
allows you to reset all setting values.
Analogue Search
The TV searches for, sorts and stores all the
receivable TV stations. Refer to “Analogue
Search” setting on page 13.
Satellite Search
After selecting “Satellite Search”, the current
DVB-S setting screen is displayed. Refer to the
“Satellite Search” setting on pages 14–15.
NOTE
After selecting “Next” in the DVB-S setting screen, you
need to select your preferred satellite broadcast to start
searching.
The “Satellite Search” has a “Reset” function. This allows
you to reset all setting values.
1
2
•
•
3
E
•
E
E
•
•
Programme Setup
Setup
Programme Setup
Digital Setting
Additional Search
Use this menu to add new services automatically after
auto installation has been completed.
Manual Search
Add new services within a specified frequency band.
Enter the frequency using the 0–9 numeric buttons.
You can perform “Manual Search” with a service number
only when the five Nordic countries have been selected in
the country setting.
Manual Adjust
Configure various settings for each service using the
Colour (R, G, B) buttons.
DTV 993
Service
No.
Old
LCN
CH
Skip
Lock
Service
Name
SIT 3
DTV 994 ✔ SIT 2
DTV 995 ✔SIT 1
DTV 999 HD Monosco
: Lock
R
: CH Skip
G
: Sort
B
Press a/b to select the desired service.
Press the colour button on the remote control
unit corresponding with the item you want to
reconfigure.
The ✔ mark indicates the operation is set to on. Each
time the colour button is pressed, you can switch the
corresponding operation on/off.
E
E
•
•
E
1
2
•
You can reconfigure each service setting automatically
or manually.
Press a/b to select the broadcast standard
you want to reconfigure, and then press OK.
Digital Setting
Satellite Setting
Analogue Setting
34
To Next Page
Loading...
Need help?
General