6.
Adjusting Gibs:
After a period of time the gibs may become loose or worn and may
need to be adjusted to maintain the integrity of the mill.
A.
Table Gib (Fig. 32):
The table gib is located between the saddle seat and the table
dovetail.
a. Loosen lock levers “L”.
b. Clean and lubricate slideways.
c. Using a screwdriver to adjust the gib screws “M” located on
both sides of the saddle. If moving the table and screws turn
loose, they can be adjusted by:
Slightly loosen the adjusting screw on the right, then tighten the
left screw. After adjusting, check movement of table. If still
loose, repeat the process until desired fit is obtained.
To Next Page
Loading...
