Sharp MX-3070N

SHARP
TEST SIMULATION
55
27
FSS Function & Setting
13
Check history of paper transport time
between sensors
14
FSS function connection test mode set
15
FSS connection status display
16
FSS alert send setting
17
FSS paper order alert setting
30
Sensor Operation & Self-Test
01
Main unit sensor check
02
Paper feed sensor check (main body)
30
Motion sensor check
40
Bypass Tray Operation & Self-Test
02
Bypass tray width adjustment
07
Bypass tray width detection manual setting
41
Original Size Operation & Adjustment
01
Document sensor operation check
02
Document sensor output setup
03
Document sensor output display
43
Fuser Setting & Adjustment
01
Fuser temperature setup for each mode
02
Fusing operation and preheat setting
20
Fuser temperature. correction for low
temperature & humidity (L/L)
21
Fuser temp correction for high temperature
& humidity (H/H)
24
Fuser temperature correction setting
35
Fusing NIP operation check
44
Process Control Data & Execution
01
Process control mode setting
02
Process control sensitivity adjustment
04
Process control initial density setup
06
High density process control correction
09
Process control data display
12
High density process control and image
sensor data display
14
Fuser temp.& humidity output data
15
OPC drum idle rotation setting
17
Process refresh execution
21
Half tone process control registration target
22
Half tone process control operation result
24
Half tone process control operation
correction data result display
44
Process Control Data & Execution
25
Initial half tone correction data display
26
Half tone process control execution
27
Half tone process control correction clear
28
Process control timing (On/Off) setting
29
Enable/disable half tone correction during
each job
31
OPC drum deflection adjustment/check
37
DV bias correction level setting for
continuous print mode.
43
DV unit installation identification check
62
Process control execution condition setting
46
Copy/Scanner Image Density Adjustment
01
Colour copy density adjustment
02
B/W copy density adjustment
04
Image Send Colour scan density adjustment
05
Image Send B/W scan density adjustment
08
Colour scanner balance adjustment RGB
09
Scan image density adjustment
10
Copy colour balance & gamma manual
adjustment
16
B/W copy density & gamma adjustment
19
B/W auto exposure mode setup
21
Copy colour balance adjustment (All)
23
Enable/disable maximum density adjustment
for copy mode
24
Copy half tone auto adjustment
25
Single colour mode colour balance set-up
26
Single colour mode colour balance reset
27
Coefficient (Black edge) gamma set-up
30
Resolution adjust (sub-scan – copy mode)
32
Document background density adjustment
36
2-colour mode adjustment (Red, Black)
37
B/W image reproduction adjustment
38
Black component adjustment (Copy mode)
39
Fax Image send sharpness adjustment
40
Fax mode exposure adjust (All modes)
41
Fax mode exposure adjust (Normal)
42
Fax mode exposure adjust (Fine Text)
43
Fax mode exposure adjust (Super Fine)
44
Fax mode exposure adjust (Ultra Fine)
45
Fax mode exposure adjustment (600dpi)
46
Fax mode exposure adjustment
(RGB RIP)
47
JPEG compression rate setting
48
Function setting for copy output
51
Heavy paper mode gamma adjustment