Sharp MX-6580N

2-33
COPIER►BASIC PROCEDURE FOR MAKING COPIES
SELECTING THE ORIENTATION AND SIZE
OF THE ORIGINAL
When the original size is a non-standard size or is not detected correctly, manually specify the original size.
Set the orientation of the image to ensure that the orientation of the placed original is correctly recognized.
Specifying the orientation of the original
By specifying the starting side (top or left side) of the placed original, the orientation of the original will be correctly
recognized.
Finishing position settings and N-Up layout settings are specified using the recognized orientation.
Specifying the orientation and size of an inch-size original
• Set the orientation and size of the original before scanning the original.
• The original size is set in normal mode.
1
Tap the [Original] key to set the orientation of the original.
► COPY MODE (page 2-3)
2
Tap the [Detail] key to change to normal mode.
► Changing mode from each mode (page 2-5)
3
Tap the [Original] key.
4
Tap the [Inch] tab.
CA
Preview
Copies
Image
Orientation
Original
B/W
Start
Color
Start
Start
Color
Start
B/W
3
411x17
8½x14
8½x11
Proof Copy
Preview CA
Others
1
No. of copies
Original
Auto
Direct Entry
InchAB Custom Size
8½x11
Image Orientation
5 ½x8 ½ 8 ½x11R 11x17
5 ½x8 ½R 8 ½x13
8 ½x11 8 ½x14
8 ½x13
2
/
5
Skip Blank Page in Original
Copy Ratio
Enlarge/Reduce Copy
Blank Page Skip
2-Sided Copy
Color Mode
Background Adjustment
In Easy mode In Normal mode