1-85
BEFORE USING THE MACHINE►LOADING PAPER
Loading envelopes
When loading envelopes into the bypass tray, place them in the orientation as shown in the figure.
Placing envelopes
Only the front side of envelopes can be printed on or copied to. Place the front side facing down.
Important points when using envelopes
• Do not print on both sides of an envelope. This may result in misfeeds or poor print quality.
• Restrictions apply to some types of envelopes. For more information, consult a qualified service technician.
• Some operating environments may cause creasing, smudging, misfeeds, poor toner fusing, or machine failure.
• Fold the flap of the envelope and make a sharp crease at the fold. A misfeed may occur if the flap is up.
• Do not use the following envelopes:
• Those with a metal piece, a plastic hook or a ribbon hook
• Those with a string for closing
• Those with a window
• Those with a lining
• Those with an uneven surface, finished with titling or emboss
• Duplex envelopes or those with adhesive or other synthetic material for sealing
• Hand-made envelopes
• Those containing air inside
• Those damaged with a crease, fold mark or tear
• Envelopes with the corner gluing position on the back not aligned with the corner edge should not be used as it may
cause creasing.
• Print quality is not guaranteed in the area 13/32" (10 mm) around the edges of the envelope.
• Print quality is not guaranteed on parts of envelopes where there is a large step-like change of thickness, such as on
four-layer parts or parts less than three layers.
• Print quality is not guaranteed on envelopes having peel off flaps for sealing the envelopes.
Can be used
Cannot be used
To Next Page
Loading...
