4-45
FACSIMILEâ–ºBASIC TRANSMISSION METHODS
SPECIFYING THE ORIGINAL SCAN SIZE IN PAPER
SIZE
When the original size is not standard (inch size or non-standard size) or is not detected correctly, manually specify the
original size.
When [Long Size] is selected, the 2-sided scanning setting and send size cannot be changed.
The image is sent in Mono2 only.
1
Tap the [Detail] key to change to normal mode.
â–º Changing mode from each mode (page 4-8)
2
Tap the [Original] key.
3
Tap the [Scan Size] key.
4
Tap the appropriate original size key.
After the settings are completed, tap .
• If you are sending a long original, tap the [Long Size] key.
Use the automatic document feeder to scan a long original. The maximum width that can be scanned is 39-3/8" (1,000
mm) (the maximum height is 11-5/8" (297 mm)).
â–º TRANSMITTABLE ORIGINAL SIZES (page 4-24)
Original
Auto
2-Sided
Tablet
2-Sided
Booklet
8½x11 8½x11Auto
Scan Size Send Size
Image Orientation
100%
Address Book
Others
Address Fax Number
Dual Page Scan
Divide into 2 Pages
N-Up
Put Multiple Pages in A Page
Slow Scan Mode
Scan Thin Paper Original
reception memory
100%
Speaker
Start
CA
Preview
Scan Size
Auto
AB Inch
Long Size
Direct Entry Custom Size
8½x11
Address Book
Others
Address Fax Number
Dual Page Scan
Divide into 2 Pages
Put Multiple Pages in A Page
Slow Scan Mode
Scan Thin Paper Original
reception memory
100%
Speaker
Start
CA
Preview
N-Up
5½x8½R
5½x8½
8½x11
8½x11R
8½x13
2
/
5
8½x13
11x17
8½x14
To Next Page
Loading...
Need help?
General
