1: Pattern 1
2: Pattern 2
Use this setting to select the layout pattern when
two original pages are copied onto a single sheet of
paper.
When enabled, this function offsets the position in
the paper output tray of sets of copies during copy
job, and print jobs when using the printer function.
When two sided copying is performed, this function
rotates the image on the back of the original. This is
convenient when binding the copies at the top
(tablet binding).
This setting is used to change the copy resolution in
AUTO and TEXT mode from 600 x 300 dpi to 600 x
600 dpi (high-quality mode). Scanning is slower
when high-quality mode is used.
If the memory fills up when two-sided copying is
performed, NORMAL can be selected to make
copying possible. However, NORMAL results in a
slower copying speed. Normally HISPEED is selected
to enable fast two-sided copying.
1: 5mm
2: 10mm
3: 15mm
4: 20mm
Use this setting to set the margin width.
1: 30%
2: 40%
3: 50%
4: 60%
5: 70%
Use this to change the proportion of machine
memory used for printer mode.
Use this setting to select whether or not holding
down a key causes repeated input of the key. For
keys that normally cause a set value to increase
when held down (for example, holding down the [<]
key [v] or [>] key [^]), this program can be used to
have the set value not change when the key is held
down.
1: NORMAL
2: 0.5 Sec.
3: 1.0 Sec.
4: 1.5 Sec.
5: 2.0 Sec.
Use this setting to select how long a key must be
pressed for the input to be accepted. By selecting a
longer time, you can prevent settings from being
changed by the accidental pressing of a key.
This sets the volume of beep signals.
To Next Page
Loading...
