37
Fax Problems
TRANSMISSION DOES NOT BEGIN AT THE
SPECIFIED TIME
Check Solution
Is the machine's clock set to the
correct time?
■ Set the clock to the correct time.
"Settings"
→
[System Settings]
→
[Common Settings]
→
[Clock]
Is a transmission in progress? ■ If another transmission is in progress when the specified time arrives, the timer
operation will begin after that transmission is finished.
PRINTING DOES NOT TAKE PLACE AFTER
RECEPTION
Check Solution
Does a password entry screen
appear?
■ Enter the correct password using the numeric keys.
[Hold Setting for Received Data Print] is enabled. If you do not know the
password, check with your administrator.
"Settings (administrator)"
→
[System Settings]
→
[Image Send Settings]
→
[Common Settings]
→
[Condition Settings]
→
[Hold Setting for Received Data Print]
Has cut-off printing been disabled in
the setting mode (administrator)?
■ Load the same size of paper as the received fax.
If [Print Actual Size Cut off Disabled] is enabled in [Print Style Setting] in the
setting mode (administrator) and a fax is received that is larger than any paper
that is loaded, the fax will be received and stored in memory without being
printed.
"Settings"
→
[System Settings]
→
[Image Send Settings]
→
[Fax Settings]
→
[Receive Settings]
→
[Print Style Setting]
Is forwarding (Inbound Routing
function) enabled for a received fax?
■ If you need to print a received fax, ask your administrator.
When the Inbound Routing function is enabled, received faxes are automatically
forwarded to a specified address. If [Print at Error] is selected when Inbound
Routing is enabled, received faxes will only be printed when an error occurs.
"Settings (administrator)"
→
[Image Send Settings]
→
[Inbound Routing (Forwarding/Storing) Settings]
→
[Administration Settings]
→
[Inbound Routing Settings]
To Next Page
Loading...
Need help?
General
