MX-C250 ADJUSTMENTS 5 – 31
Check to insure that the SIT chart (UKOG-0280FCZZ or
UKOG-0280FCZ1) is in close contact with the document table.
UKOG-0280FCZZ is equivalent to UKOG-0280FCZ1.
2) Enter the SIM 63-3 mode and press [EXECUTE] key.
The automatic operation is started. During the adjustment,
[OK] is highlighted. After completion of the adjustment, [OK]
returns to the normal display.
Since the SIT chart (UKOG-0280FCZZ or UKOG-0280FC Z1)
is easily discolored by sunlight (especially ultraviolet rays) and
humidity and temperature, put it in a bag (such as a dark file)
and store in a dark place of low temperature and low humidity.
9-B Copy/Printer color balance and density
adjustment (Automatic adjustment)
(Basic adjustment)
This adjustment must be performed in the following cases:
* When a consumable part (developer, OPC drum, transfer belt) is
replaced.
* When the CIS unit is replaced.
* When the scanner (reading) section is disassembled.
* When the scanner (reading) unit is replaced.
* U2 trouble has occurred.
* When the MFP PWB is replaced.
a. General
The color balance adjustment (automatic adjustment) is used to
adjust the copy/printer density of each of Cyan, Magenta, Yellow,
and Black automatically.
When this adjustment is executed, the color balance adjustments
of all the copy/printer modes are revised.
To Next Page
Loading...
