MX-C250 SIMULATION 6 – 1
MX-C250
Service Manual
[6] SIMULATION
1. General (Including basic operations)
The simulation mode has the following functions, to display the
machine operating status, identify the trouble position and causes
in an earlier stage, and make various setups and adjustments
speedily for improving the serviceability of the machine.
1) Various adjustments
2) Setting of the specifications and functions
3) Canceling troubles
4) Operation check
5) Counters check, setting, clear
6) Machine operating conditions (operation hysteresis), data
check, clear.
7) Various (adjustments, setting, operation, counters, etc.) data
transport.
The operating procedures and displays depend on the design of
the operation panel of the machine.
A. Starting the simulation
Entering the simulation mode
1) Machine in Copy mode: Select [READ-END] (#) key -> Aster-
isk (*) key -> [C] key -> Asterisk (*) key -> Ready for input of
main code of simulation.
2) Entering a main code with the 10 key -> [OK]/[START] key ON.
3) Entering a sub code with the 10 key -> [OK]/[START] key ON.
4) Select an item with the Arrow key.
5) The machine enters the mode corresponding to the selected
item. Press [OK]/[START] key or [EXECUTE] key to start the
simulation operation.
To cancel the current simulation mode, press [CA] key. To
change the main code and the sub code, press [C] key.
Canceling the simulation mode to return to the normal mode
1) Press [CA] key.
CAUTION: Do not turn OFF the power when the machine is in the
simulation mode.
If the power switch should be turned OFF in the simula-
tion mode, a malfunction may result. In this case, turn
OFF/ON the main power source.
1
‘13/Aug
2 ‘13/Oct
To Next Page
Loading...
Need help?
General
