46
REMOVING MISFEEDS
When a paper misfeed occurs, the message "A misfeed has occurred." will
appear in the display and printing will stop. In this event, select the
[Information] key in the display. When the key is selected, instructions for
removing the misfeed will appear. Follow the instructions. When the misfeed
is cleared, the message will automatically clear.
The blinking mark in the image at left indicates the approximate position
of the misfeed.
Select the [Information] key to
display the following screen.
(A)Instructions for removing the
misfeed appear here.
(B)Animation showing what to
do.
(C)Display the previous screen
or the next screen.
(D)This closes the information
screen.
The information screen cannot be
closed until the misfeed is removed.
For detailed procedures for removing misfeeds, see "REMOVING
MISFEEDS" in "Chapter 4 - TROUBLESHOOTING" in the Operation Guide.
Misfeed location
(A)
(C)
(D)
(B)
•
While the message appears, printing cannot be resumed.
• If the message does not clear even after the misfeed has been
removed, the causes below are possible. Check once again.
- The misfeed was not correctly removed.
- A torn piece of paper remains in the machine.
- A cover or unit that was opened or moved to remove the misfeed
was not returned to its original position.
mxc400p_us_qck.book 46 ページ ２００９年１０月５日 月曜日 午後３時４２分
To Next Page
Loading...
Need help?
General
