Upgrading and migrating
Hardware
Available internal options
• Memory cards
– PCIe
– DDR3 DRAM
– Flash memory
• Optional cards
– Font cards
– Firmware cards
• Forms and Bar Code
• PRESCRIBE
• Printer hard disk (SATA)
Note: Some options are available only in some printer models.
Accessing the controller board
CAUTION—SHOCK HAZARD: To avoid the risk of electrical shock, if you are accessing the controller
board or installing optional hardware or memory devices sometime after setting up the printer, then turn
the printer o, and unplug the power cord from the electrical outlet before continuing. If you have any
other devices attached to the printer, then turn them o as well, and unplug any cables going into the
printer.
1 Turn o the printer.
2 Unplug the power cord from the electrical outlet, and then from the printer.
3 Using a flat‑head screwdriver, remove the controller board access cover.
Warning—Potential Damage: Controller board electronic components are easily damaged by static
electricity. Touch a metal surface on the printer before touching any controller board electronic
components or connectors.
Upgrading and migrating 144
To Next Page
Loading...
Need help?
General
