Sharp MX-FX11 - Page 16

MX-FX11 FAX SOFTWARE SWITCH 2 – 12
40 1 Not used
2 Reception Setting to refuse
reception at times of
manual reception
(FAX)
Setting to determine whether or not to validate refusal of reception of
designated numbers. However, only at times of manual reception.
"0": Receipt of designated number is not refused (invalid)
"1": Receipt of designated number is refused (valid)
However, at times of automatic reception, perform using a separate SW
(Setting to refuse reception at times of automatic reception).
Only valid in cases where the "Specified number reception Enable/Disable
setting (FAX)" is refused.
3 Reception TSI judgment setting
(no signal or all space)
when refusing
reception from
designated numbers
Setting to determine whether to refuse or permit reception when there are no
TSI signals from the other party’s machine or signals are all spaced in cases
where the refusal of designated number reception set by system setting is
valid.
"0": Reception will be permitted.
"1": Reception will be refused.
Only valid in cases where the "Specified number reception Enable/Disable
setting (FAX)" is refused.
4 Reception TSI judgment setting
(No numbers and no
space can be used.)
when refusing
reception from
designated numbers
Setting to determine whether to refuse or permit reception when TSI signals
from the other party’s machine are no numbers and no space can be used
reception set by system setting is valid.
"0": Reception will be permitted.
"1": Reception will be refused.
Only valid in cases where the "Specified number reception Enable/Disable
setting (FAX)" is refused.
5 Communication PIN code
correspondence
Setting to determine whether or not to limit FAX dial number display to 16 digits.
When this is set to "1: Correspond," FAX number display based on the resend
key and the other party’s number on the job status completion screen are
displayed from the start to the 16th digit. When this SW is set as valid, it is also
reflected in report contents.
"0": Do not correspond
"1": Correspond
FAX address display limit (displayed up to the 16th digit from the front)
6-8 Not used
41 1 Not used
2 Function Reversion from the
energy saving state
(excluding preheat)
when the external
telephone is off-hook
Setting to determine whether or not to revert from energy saving with the
external telephone off the hook in the energy saving state (excluding preheat).
"0": Do not revert
"1": Revert
3 Not used
4 Function Scope of line sound
monitor
Setting to determine the scope of monitoring when the line monitor function is
used
When "Until NSF signal send/receive" is set, monitoring is conducted until the
DCS or NSF signal is received. When "All" is set, everything is monitored until
the line is disconnected.
"0": Until NSF signal send/receive
"1": All
Setting of line monitor sound ON/OFF is done by a separate SW.
5 Call arrival V150V24 detection
setting
Setting of detection when non-ringing setting is received.
"0": 24V detection
"1": 150V detection
6-8 Not used
42
-
89
1-8 Not used
SW
No.
Bit
No.
Item SW selection and function System settings