MX-M200D SIMULATIONS 7-16
24 02 Trouble memory clear
Used to clear the trouble memory and the trouble history data in the EEPROM.
When [INTERRUPT] key is pressed, the machine shifts to the sub code input window. When [CA] key is
pressed, the machine exits the simulation mode.
(Only when the
SPF/RSPF is
installed.)
04 SPF/RSPF counter clear
Used to clear the SPF/RSPF paper feed counter.
[CA] key: Exits the simulation mode.
[INTERRUPT] key: Shifts to the sub code input window.
05 Duplex print counter clear
Used to clear the duplex print counter.
[CA] key: Exits the simulation mode.
[INTERRUPT] key: Shifts to the sub code input window.
(MX-M200D/MX-
M160D only)
(Execution is not
allowed when
DUPLEX setting is
OFF.)
06 Paper feed counter clear
Used to clear the paper feed counter data in each paper feed section.
* TRAY2-TRAY4 are displayed only when they are installed.
[CA] key: Exits the simulation mode.
[INTERRUPT] key: Shifts to the sub code input window.
07 Drum counter clear
Used to clear the drum counter and the drum rotating time.
[CA] key: Exits the simulation mode.
[INTERRUPT] key: Shifts to the sub code input window.
Main
code
Sub
code
Contents Remark
Sim24-2 COUNTER CLR
AER YOU SURE? EXEC
TROUBLE
COUNTER
CLEAR
Sim24-4 COUNTER CLR
AER YOU SURE? EXEC
SPF
COUNTER
CLEAR
Sim24-5 COUNTER CLR
AER YOU SURE? EXEC
DUPLEX
COUNTER
CLEAR
Sim24-6 COUNTER CLR Sim24-6 COUNTER CLR Sim24-6 COUNTER CLR
Numeric
Key
1:BYPASS
2:TRAY1
3:TRAY2
4:TRAY3
5:TRAY4
0
1:BYPASS
2:TRAY1
3:TRAY2
4:TRAY3
5:TRAY4
2
1:BYPASS
2:TRAY1
3:TRAY2
ARE YOU SURE?
4:TRAY3
5:TRAY4
2
[C] Key
[OK] key or
[START] key
[OK] key or
[START] key
Return
(Initial window (Counter selection window) (Confirmation window)
Sim24-7 COUNTER CLR
AER YOU SURE? EXEC
DRUM
COUNTER
CLEAR
To Next Page
Loading...
