Each instruction also covers the optional units used with these products.
Shielded interface cables must be used with this equipment to maintain compliance with EMC regulations.
In some areas, the "POWER" switch positions are marked "I" and " " on the copier instead of "ON"
and "OFF".
The symbol " " denotes the copier is not completely de-energized but in a stand-by condition at
this "POWER" switch position.
If your copier is so marked, please read "I" for "ON" and " " for "OFF".
Caution!
For a complete electrical disconnection, pull out the main plug.
The socket-outlet shall be installed near the equipment and shall be easily accessible.
To Next Page
Loading...
Need help?
General
