LOADING PAPER
2-11
2
■ Important points when using the
bypass tray
● Be sure to load A5 paper, 5-1/2" x 8-1/2" paper,
and postcards as shown (1) horizontal loading in
the diagram below.
(1):Horizontal loading
(2):Vertical loading
● When loading plain paper other than SHARP
standard paper, special media other than
postcards, SHARP-recommended transparency
film, or paper to be printed on the back, the
paper must be loaded one sheet at a time.
Loading more than one sheet at a time will cause
misfeeds.
● Before loading heavy paper, straighten any
curling in the paper.
● When adding paper, remove any paper
remaining in the tray, combine it with the paper to
be added, and reload as a single stack.
● Do not use paper that has already been printed
on by a plain paper fax machine or a laser
printer. This may cause printed images to
become dirty.
● When printing on transparency film, be sure to
remove each sheet as it exits the machine.
Allowing sheets to stack in the output tray may
cause curling.
● Use only Sharp-recommended transparency
film. Transparency film should be loaded in the
bypass tray with the label facing down and the
film oriented vertically. Smudging and a dirty
image may result if the film is placed with the
label facing up.
● When loading multiple sheets of transparency
film in the bypass tray, be sure to fan the sheets
several times before loading.
● Use only tabbed sheets that are made of paper.
Tabbed sheets made of film or other material
cannot be used.
(1) (2)
Label facing down
To Next Page
Loading...
Need help?
General
