PN-L803C_80TC3 FIRMWARE UPDATE PROCEDURES 5 - 3
1-5. CONFIRM VERSION OF FIRMWARE BY SERVICE MENU
With the image being displayed, use the remote copntroller and display SERVICE MENU1. Then, confirm the version of the firmwares.
Press the [SIZE] button of the remote control for about 5 seconds (the LED blinks, and the “F” mark is displayed in the upper left corner of
screen.), press the [BRIGHT- ( )], [VOL - ()] , [BRIGHT+ ()] and [VOL+ ()] button in sequence. Press [MENU] button on the
controller to close SERVICE MENU1 after the versions are confirmed.
<CAUTION>
Do not perform the firmware update and the internal controller update at the same time.
SERVICE1
SERVICE2
SERVICE3
SERVICE MENU1 1/1
MODEL ： PNxxxxx S/N ： XXXXXXXX
INTEGRATED VERSION ： Ver 1.0.2.0
VER (MAIN) : OK Ver 1.00 (150101) C/S：OK 1234ABCDEF
VER (SUB) : OK Ver 1.00.10 (150101) C/S：OK 1234ABCD
VER (TPFW) : OK Ver 1.00 C/S：OK 1234ABCD
VER (TPCON) : OK Ver 1.00 C/S：OK 1234ABCD
VER (DP RX) : OK Ver 1.2.4.117 C/S：OK 1234ABCD
VER (DP TX) : OK Ver 1.1.4.6 C/S：OK 1234ABCD
VER (DSD) : OK Ver 8.32 VER(KEY) : OK Ver1.00
VER(LCD) : OK 2014013080435100
USAGE TIME ： 100H
ADJUSTMENT CHECK ： W/B CALIB
END・・・[MENU]
To Next Page
Loading...
