>>
<<
Introduction
Initial Installation (Continue)
Power Saving
Select "Yes" or "No" to configure default Display settings.
2 Press / to select "Yes" or "No".
Press ENTER to enter the setting.
Yes: AV MODE is set to "STANDARD" and Automatic Light
Sensor is set to "On".
No: AV MODE is set to "DYNAMIC (Fixed)" and Automatic
Light Sensor is set to "Off". Picture Reset can be set.
Picture Reset: AV MODE will be set to "DYNAMIC (Fixed)"
regardless of whether Picture Reset is "On" or "Off".
If you select "On" and there is no operation for 30 minutes:
- AV MODE will be reset to "DYNAMIC (Fixed)".
When "Off" is selected:
- Even after 30 minutes elapses, AV MODE is not reset to
"DYNAMIC (Fixed)".
ENG 2-3
To Next Page
Loading...
Need help?
General
