>>
<<
On-Screen Display Menu
Example
Network Settings
Dashboard
You can display a list of the main Network settings.
Wired Setup
You can make adjustments manually for the IP.
You can switch the "Connect Type" to "AUTO" or "Manual".
Check that numbers are display for each setting.
If there are any settings without numbers, specify the
numbers by following the on-screen instructions.
Inputs the IP address etc by using remote control buttons
0-9.
IP Control
Set this function when operating the Monitor from equipment
connected by LAN.
(See page 7-3.)
ENG 4-16
To Next Page
Loading...
