>>
<<
Using a PC
Adjusting the PC Image
You can adjust the position of the image input from a PC by selecting "Initial Setup" > "Input
Settings" > "Fine Sync.".
Fine Sync.
Ordinarily you can easily adjust the picture as necessary to change image position using "Auto
Sync.". In some cases, however, manual adjustment is needed to optimize the image.
Input Signal: Select the input signal.
1024x768
1360x768
Auto Sync.: For automatically adjusting the PC image.
Yes: Auto Sync. starts and "Now adjusting the image." is displayed.
No: This function does not work.
H-Pos.: Centers the image by moving it to the left or right.
V-Pos.: Centers the image by moving it up or down.
Clock: Adjust when the image flickers with vertical stripes.
Phase: Adjust when characters have low contrast or when the image flickers.
NOTE
"Auto Sync." may fail if the computer image has low resolution, has unclear (black) edges, or is
moved while executing "Auto Sync.".
Be sure to connect the PC to the Monitor and switch it on before starting "Auto Sync.".
It is not necessary to adjust the "Clock" or "Phase" when a digital signal is being input, so it cannot
be selected.
The default cursor position may not be in the center, because the screen position variable ranges
may be asymmetrical.
The screen position variable ranges depend on the View Mode or the signal type. The ranges can
be seen on the position-setting screen.
ENG 7-1
To Next Page
Loading...
Need help?
General
