Sharp PN-T321 - Monitor Power Management; Turning the Monitor On and Off; Disabling Power Operations

13
E
Turning Power On/Off
Caution
• Turn on the monitor rst before turning on the PC or
playback device.
Turning on the main power
Main power switch
Caution
• The main power must be turned on/off with the main power
switch. Do not connect/disconnect the power cord or turn
the breaker on/off while the main power switch is on.
• When switching the main power switch or the POWER
button off and back on, always wait for at least 5 seconds.
• For a complete electrical disconnection, pull out the main
plug.
Turning power on/off
Press the POWER button or POWER switch to turn the power
ON/OFF. When the main power is off, the power cannot be
turned on with the POWER button.
Power LED
• Status of the power LED
Status Status of the monitor
Green lit Power on
Orange lit Power off (Standby mode)
Green ashing
Input signal waiting mode
(DVI-D or D-SUB)
Caution
• When switching the main power switch or the POWER
button off and back on, always wait for at least 5 seconds.
A short interval may result in a malfunction.
TIPS
• If the monitor is in the input signal standby mode and you
press the POWER button on the remote control unit, the
monitor enters standby mode.
Disabling power on/off operations
Power on/power off operations can be disabled in order to
protect the monitor from an accidental power off. Set the
ADJUSTMENT LOCK in FUNCTION menu to “2”. (See page
21.)