Sharp PN-T321 - Basic Monitor Operation; Input Source Selection; Volume and Brightness Control; Display and Color Mode Settings

14
E
Basic Operation
1
2
3
4
5
6
7
8
1. INPUT (Input mode selection)
The menu is displayed. Press
or to select the input
mode, and press
to enter.
* You can select the input terminal by pressing the input
switch of the monitor.
Input mode Video Audio
DVI-D PC/AV DVI-D input terminal
PC audio input
terminal
D-SUB PC D-sub input terminal
HDMI PC/AV HDMI input terminal
*1
COMPONENT AV COMPONENT input terminal
AV audio input
terminal
VIDEO AV video input terminal
USB
*2
USB port
-
*1 If audio will be not input by HDMI cable, use the PC audio
input terminal.
*2 Image and audio les in the USB ash drive can be
displayed/played. For details, see page 19.
2. MUTE
Turns off the volume temporarily.
Press the MUTE button again to turn the sound back to the
previous level.
3. MENU
Displays and turns off the menu screen (see page 18).
4. VOL +/- (Volume adjustment)
Pressing
or displays the VOLUME menu when the
menu screen is not displayed.
15
VOLUME
Press or to adjust the volume of the sound.
* If you do not press any buttons for about 4 seconds, the
VOLUME menu automatically disappears.
5. BRIGHT +/- (Backlight adjustment)
Pressing
or displays the BRIGHT menu when the menu
screen is not displayed.
15
BRIGHT
Press or to adjust the brightness.
* If you do not press any buttons for about 4 seconds, the
BRIGHT menu automatically disappears.
6. SIZE (Screen size selection)
The menu is displayed.
Press
or to select the screen size. (See page 15.)
* When the input mode is USB, the screen size cannot be
changed.
* The menu disappears after about 4 seconds if you do not
press any buttons.
7. DISPLAY
Displays monitor information. When you press this button
again, the display disappears.
* The display disappears automatically after about 15
seconds.
8. MODE (Color mode selection)
Each time you press this button, the color mode changes in
the following order:
STD (Standard) → VIVID → sRGB → STD...
• sRGB can only be selected when the input mode is DVI-D
or D-SUB.
sRGB is international standard of color representation
specied by IEC (International Electrotechnical
Commission). Color conversion is made in taking account
of liquid crystal’s characteristics and represents color tone
close to its original image.