Sharp RP-7700H - Loading and Playing a CD; CD Loading Steps; Initiating CD Playback; CD Disc Handling Cautions

Cautions:
@ Never attempt to force open the CD compartment cover
without pressing the EJECT button, or to pull the open cover
out farther than it comes by itself.
@ Do not attempt to open the CD compartment whilst the disc is
rotating. If the EJECT button is pressed without first pressing
the STOP/CLEAR button, the disc compartment may. open
whilst the disc is rotating, thus damaging the disc.
@ Loading and playing a disc
1 Set the POWER switch to ON.
2 Press the CD button.
3 Press the EJECT button to open the CD compartment.
4 Place the disc in the disc holder of the CD compartment with
the label on the disc facing you.
A. For a 12 cm (5”) disc, place the disc correctly in the 12 cm
(5”) disc holder (1).
Don’t place a 12 cm (5”) disc in the 8 cm (3”) disc holder (2).
B. For a 8 cm (3") disc, place the disc correctly in the 8 cm (3”)
disc holder (2). ‘
Don’t place a 8 cm (3”) disc in the 12 em (5"} disc holder (1) .
Notes:
When inserting the disc, note the following cautions. If the disc
is inserted incorrectly, it could damage the disc and/or the CD
player.
®@ Always place the disc on the cover side of the disc compart-
ment.
(Never place a disc on the spindle side.)
@ Place the disc only when the disc compartment cover is
completely open. (Never place a disc when the cover is
only partially open.)
@ Place the disc correctly in the 12 cm (5”) or the 8 cm (3”) disc
holder.
5 Check to be sure that the disc is inserted correctly, and then
close the CD compartment. Push the centre of the CD com-
partment to close the compartment securely.
@ First the total number of tracks will appear in the display, and
then the track number "01” will appear.
6 Press the PLAY button to start playback from track 1.
@ The MINUTE/SECOND indicator will blink during playback if
the disc is scratched or soiled.
@ If CD is damaged, dirty, or loaded upside down, display will
show error signs as follows.
+ “Cd” does not stop flashing.
* Total track number or “01” is not displayed.
+ “Er” is displayed:
Clean, replace, or load CD properly.
@ Subjecting unit to shock or vibration can cause mistracking.
@ Keep CD compartment closed except when loading CDs.