Sharp SF-7300 - Page 34

SF-73M
SF–7350
copy hmp pulby angb A
‘Ly?
Ly
o
C~y kmp pulby angk B
%
C*Y lamp harness
copy lamp pulby
Copy lampharnessguide
(4)
(~
Udasten the frontframs ~ mnectti.
Remove the copy lamp harnesscti~m~m the frame.
Remove the copylampgroundscrew.
Remove the qy lamp harnessguidefromthe bne baseplate,
Cqy bmp harness
Groundscrew
Copy lamp harness
guide
Contior
Lens base pbte “
Lensba~ate latch
(6) Rmwethewirec~mp.
Remove the copy kmp harness from the copy lamp harness
guide.
(q Remove the copy krnp connectorangb from the copy lamp
unit.
.Copy hmp connectorangh
(8) Remove the connectionshi~ pkte hoHing screw and move
the plate towardsthe paper eexh side, h referenceto [8} I-E-
(4p(q.
(9) Turn the copy lamp connectorhtiing brack~ qeide down as
shownin the ~re.
8–5
Connectbn shi~ pfate<movetowardsthe paper exit side).
(10) Remove the copyhmp harnessfromthe copy kmp connectm.
$
copy
Reverse the ~uence to ~assembk withthe followingprecautbn:
● The bopback @n must be withintire. The copy hmp hsr-
ness must rest inthe Are damp groove.
5mm, max.
\,
Wire damp
●
✎
●
When irr~brg the copylamp harnessonthe cqy kmp harness
guide, the ~ck taped_ of the copy bmp harnessmustbe
at the center of the tire cfamp.
The
copyhm hamese must rest on the harne~ h-r of the
copy tip hamese
guide.
CM that the -y lamp harness does not c~hd the mirra
Ham~s hoHer
copy
ire
lam
damp
.