Sharp TU-GA1U-S - Power Control Settings (Continued); PC Power Management Modes

42
Basic adjustment settings
No signal off
When set to “Enable”, the power will automatically shut
down if no signal inputs for 15 minutes.
Press a/b to select “No Signal Off”, and
then press ENTER.
Press c/d to select “Enable”, and then
press ENTER.
3
4
• Five minutes before the power shuts down,
remaining time displays every minute.
NOTE
• “Disable” is factory preset value.
• When a TV program finishes, and the AVC System receives
signal input, this function may not operate.
Press c/d to select “Power Control”.
Press MENU and the MENU screen displays.
No operation off
When set to “Enable”, the power will automatically shut
down if there is no operation for 3 hours.
Press a/b to select “No Operation Off”, and
then press ENTER.
Press c/d to select “Enable”, and then
press ENTER.
• Five minutes before the power shuts down,
remaining time displays every minute.
NOTE
• “Disable” is factory preset value.
Press c/d to select “Power Control”.
Press MENU and the MENU screen displays.
2
1
MENU
[
Power Control
...
No Signal Off
]
Power Control Setup
No Signal Off
No Operation Off [Disable]
[Disable]
DisableEnable
3
4
2
1
MENU
[
Power Control
...
No Operation Off
]
Power Control Setup
No Signal Off
No Operation Off [Disable]
[Disable]
DisableEnable
Power control
Power control setting allows you to save energy.
Power control for AV source
LC-32/37G4U(E)-35-43 04.4.7, 2:30 PM42