Sharp TU-GA1U-S - Using Memory Card; Important Notes on Memory Card Usage

43
Power control for PC source
Power control setting allows you to save energy.
Basic adjustment settings
Power management
When set, the power will automatically shut down.
Press a/b to select “Power Management”,
and then press ENTER.
Press a/b to select “Mode1” or “Mode2”,
and then press ENTER.
Description
• No power management
• Factory preset value.
• If no signal inputs for 8 minutes, the power
shuts down.
• Even if you start using the PC and the signal
inputs again, the System stays off.
• The System turns on again by pressing
POWER button on the Display or TV
POWER on the remote control unit. (See
page 24).
• If no signal inputs for 8 seconds, the power
shuts down.
• When you start using the PC and the signal
inputs again, the System turns on.
Selected item
Off
Mode1
Mode2
Press c/d to select “Power Control”.
Press MENU and the MENU screen displays.
3
4
2
1
MENU
[
Power Control
...
Power Management
]
Power Control Setup
Power Management [Off]
Off
Mode1
Mode2
LC-32/37G4U(E)-35-43 04.4.7, 2:30 PM43