Sharp UX-460 - Dial Mode

Setting 7: TRANSACTION REPORT PRINT SELECT
This sets the condition for printing out a Transaction Report. Enter a
number from 1 to 5 as follows:
1 (ALWAYS PRINT): A report will be printed after each
transmission, reception, or error.
2 (ERR/TIMER/MEM): A report will be printed after an error, timer
operation, or memory operation.
3 (SEND ONLY): A report will be printed only after a
transmission.
4 (NEVER PRINT): A report will never be printed.
5 (ERROR ONLY): A report will be printed only after an error
occurs.
• Initial setting: 5
FUNCTION
4
Press
until
display
shows:
TRANSACTION LIST
STOP
Enter a number
from
1 to 5
DIAL MODE
Setting 8: DIAL MODE
This sets the mode of dialing. Press 1 if you are on a touch-tone line, or
2 if you are on a pulse dial line. (If you don’t know which type of line
you have, try making phone calls with both settings and see which one
works.)
• Initial setting: 1
FUNCTION
4
Press
until
display
shows:
DIAL MODE
STOP
21
TONE PULSE
or
DISTINCTIVE RING
Option Settings
114