Telephone line cord
Insert one end of the line cord into the jack on the back of the machine
marked TEL. LINE. Insert the other end into a standard (RJ11C)
single-line wall telephone jack.
Be sure to insert the
telephone line cord into
the
TEL. LINE jack.
Do not insert it into the
TEL. SET jack!
Comments:
•• Your fax is set for touch-tone dialing. If you are on a pulse dial (rotary) line,
you must set the fax for pulse dialing by changing Option Setting 8. This
procedure is described in Chapter 8, Option Settings.
•• If you intend to use a computer fax modem on the same phone line, you must
reset Option Setting 10 (Fax Signal Receive) to NO in order to prevent
transmission and reception errors. This procedure is described in Chapter 8,
Option Settings.
TEL.
SET
TEL.
LINE
Connections
14
To Next Page
Loading...
