SERVICE MANUAL
MODEL SELECTION CODE DESTINATION
UX-P115 U U.S.A.
UX-P115U
No. 00ZUXP115USME
FACSIMILE
UX-P115
MODEL
SHARP CORPORATION
CONTENTS
Parts marked with " " are important for maintaining the safety of the set. Be sure to replace these parts with specified ones for
maintaining the safety and performance of the set.
This document has been published to be used
for after sales service only.
The contents are subject to change without notice.
CHAPTER 1. GENERAL DESCRIPTION
[1] Specifications ................................................. 1-1
[2] Operation panel.............................................. 1-2
[3] Transmittable documents............................... 1-3
[4] Installation ...................................................... 1-4
[5] Quick setup guide .......................................... 1-8
[6] Quick reference guide .................................... 1-9
[7] Option imaging film specifications.................. 1-9
CHAPTER 2. ADJUSTMENTS
[1] Adjustments ................................................... 2-1
[2] Diagnostics and service soft switch ............... 2-2
[3] Troubleshooting ........................................... 2-20
[4] Error code table............................................ 2-21
CHAPTER 3. MECHANISM BLOCKS
[1] General description ........................................ 3-1
[2] Disassembly and assembly procedures......... 3-3
CHAPTER 4. DIADRAMS
[1] Block diagram ................................................ 4-1
[2] Wiring diagram ............................................... 4-2
[3] Point-to-point diagram.................................... 4-3
CHAPTER 5. CIRCUIT DESCRIPTION
[1] Circuit description ..........................................5-1
[2] Circuit description of control PWB ................5-2
[3] Circuit description of TEL/LIU PWB...............5-9
[4] Circuit description of power supply PWB......5-12
[5] Circuit description of CIS unit ......................5-12
CHAPTER 6. CIRCUIT SCHEMATICS AND PARTS
LAYOUT
[1] Control PWB circuit .......................................6-1
[2] TEL/LIU PWB circuit......................................6-9
[3] Power supply PWB circuit ...........................6-12
[4] Operation Panel PWB circuit .......................6-14
CHAPTER 7. OPERATION FLOWCHART
[1] Protocol .........................................................7-1
[2] Power on sequence.......................................7-2
CHAPTER 8. OTHER
[1] Service tools ..................................................8-1
[2] Changing the record paper size ....................8-4
Parts Guide
To Next Page
Need help?
General
