To Next Page

To Previous Page

UX-P115U

2 – 4

3.12. Entry data receive

In this mode, the registered data sent from the other machine is receiv-

ed and the received data is registered in the machine. When this mode

is used for receiving, the other machine must be in the entry data send

mode.

After receiving is completed, the following lists are printed.

1.Telephone list data

2.Sender register data (*)

3.Optional setting list (*)

4.Soft switch content

5.Junk fax number list (*)

6.Recording setting list data (*)

(*): Refer to SETUP LIST

4. How to make soft switch setting

To enter the soft switch mode, press the following key entries in sequence.

Press

FUNCTION

9 8 7 STARTSTART

Press FUNCTION key.

Press key.

Bit1 - 8 are set.

Soft SW-A2 - SW-O6 are set.

S F T SW-A1 = 10000000

S F T SW-A2 = 00000000

S F T SW-O6 = 00000000

Press key during setting.

To finish the settings halfway between

SW-A1 and SW-O6, press the STOP

key. In this case, the setting being done

to the SW No. on display will be nullified

while settings done to the preceding

SW No. remain in effect.

The soft switch mode is terminated.

S F T SW-A1 = 00000000

START

DATA No. 1 2 3 4 5 6 7 8

When the COPY key is pressed, the

contents of soft switches are printed.

Sharp UX-P115 User Manual

Questions and Answers: