UX-P115U
1 – 1
FAXUX-P115UService ManualService ManualMarketE
CHAPTER 1. GENERAL DESCRIPTION
[1] Specifications
Automatic dialing:
Imaging film:
Memory size*:
Modem speed:
Transmission time*:
Resolution:
Automatic document
feeder:
Recording system:
Halftone (grayscale):
Compression scheme:
Display:
Applicable telephone line:
Paper tray capacity:
30 numbers
Initial starter roll:
(included with machine): 32 ft.(10 m)
(approx. 30 letter-size pages)
Replacement roll (not included):
UX-5CR 164 ft.(50 m) (one roll yields
approx. 150 letter-size pages)
448 KB (approx. 24 average pages)
9,600 bps with automatic fallback to
lower speed
Approx. 15 seconds
Horizontal: 203 pixels/inch (8 dots/mm)
Vertical:
Standard: 98 lines/inch (3.85 lines/mm)
Fine/Halftone: 196 lines/inch
(7.7 lines/mm)
Super fine: 391 lines/inch
(15.4 lines/mm)
10 pages max. (letter/A4, 20-lb. paper)
Thermal transfer recording
64 levels
MR, MH, Sharp(H2)
16-digit LCD display
Public switched telephone network
Letter: Approx. 50 sheets (20-lb. copier
paper at room temperature; maximum
stack height should not be higher than
the line on the tray)
Legal: 5 sheets
Recommended paper weight is 20-lb.
Copy Bond
Compatibility:
Input document size:
Effective scanning width:
Effective printing width:
Contrast control:
Reception modes:
Copy function:
Telephone function:
Power requirements:
Operating temperature:
Humidity:
Power consumption:
Dimensions (without
attachments):
Weight (without attach-
ments):
ITU-T (CCITT) G3 mode
Automatic feeding:
Width: 5.8 to 8.5” (148 to 216 mm)
Length: 5.5 to 11” (140 to 279 mm)
Manual feeding:
Width: 5.8 to 8.5” (148 to 216 mm)
Length: 5.5 to 23.6” (140 to 600 mm)
8.3” (210 mm) max.
8.3” (210 mm) max.
Automatic/Dark selectable
TEL/FAX
Single / Multi (99 copies/page)
Yes
(cannot be used if power fails)
120 V AC, 60 Hz
41 - 95°F (5 - 35°C)
25 - 85 % RH
Stand-by: 3.6 W
Maximum: 100 W
Width: 12.9” (327 mm)
Depth: 7.6” (193 mm)
Height: 6.4” (163 mm)
Approx. 6.2 lbs (2.8 kg)
*Based on Sharp Standard Chart at standard resolution in Sharp spe-
cial mode, excluding time for protocol signals (i.e., ITU-T phase C
time only).
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement
without prior notice. The performance specifications figures indicated are nominal values of production units. There may be some deviations from
these values in individual units.
To Next Page
Loading...
Need help?
General
