Sharp VC-A410X

n Setting the Channels ____________________
Your VCR can receive VHF channels 0 to 12, and UHF channels 28 to 69. Your VCR has 48
programmable channel positions, each of which can be set to any of the above broadcast
channels. The channel positions have been preset at the factory as shown below.
I NOTE >
Position
Preset TV Channel
Position
Preset TV Channel
• Use the A / ▼ / ◄ / ► buttons on the remote
control to set the OSD.
• Channel position numbers 1, 3, 4, 8, 11 to 27, and
29 to 46 have been factory set to be skipped when
the CHANNEL © or © button is used.
• If the picture is not clear, if you want a different
channel from the one preset or if you wish to reset a
skipped channel, reset the channel as follows.
0
-
8 Skipped channel
1
Skipped channel
9
VHF 9
2
VHF 2 10
VHF 10
3
Skipped channel
11-27
Skipped channel
4
Skipped channel
28
UHF 28
5
VHF 5A
29-46 Skipped channels
6
VHF 6
7
VHF 7
47
-
AUTO TUNING
PREPARATION
•Select the video channel on your TV. Press the OPERATE button to turn on the VCR.
MENU
o
MENU
TIMER
MODE
CLOCK
LANGUAGE
SELECT sA ▼
ENTER : SET EXIT : MENU
▲ SET
v
O Press the MENU button.
Select item “ CHANNEL PRESET ” with the A/V
buttons, and press the SET button.
▲
or
r J *" ..
CHANNEL PRESET
MANUAL
SELECT :A ▼
ENTER : SET EXIT sMENU
I ................... ----- ....... -J
SET
©
@ Select item “ AUTO ” with the A/V buttons and
press the SET button.
1 NOTE >
• CHANNEL PRESET has been preset to MANUAL at
the factory.
1
AUTOMATIC TUNING.
PLEASE WAIT.
■■ ------------------------------------------------------
EXIT : MENU
L-. ...........................
a Normal
“ Screen
© The channel display on the TV screen will con 
tinue through all of the channels and when
finished, the TV screen will return to the normal
screen.
I NOTE >
• If additional unwanted channels were found, refer to page 14 to skip unwanted channels.
• If some channels were unable to be found, please refer to page 13 for Manual Tuning.
12