Sharp VC-A410X

gg Recording with the Timer ________________
The timer can be set manually for automatic recording of up to 8 events over a 365 day period.
PREPARATION
• Load the cassette, ensuring the erasure protection hole is covered. The VCR power will automatically
turn on.
• Check that the clock is displaying the correct time. (See Setting the Clock on page 11.)
PROCEDURE
Example: Recording channel position 47 in SP mode from 12:00 PM to 12:30 PM, December 15,
1997, if the present time is 10:28 (morning), December 14, 1997.
[Menu]
MODE
CHANNEL PRESET
CLOCK
LANGUAGE
SELECT :A ▼
ENTER : SET EXIT : MENU
o Press the MENU button.
Select the TIMER-setting mode and press the
SET button.
[Timer position]
CANCEL : CLEAR
ENTER : SET EXIT : MENU
When the clock is
set to 24H mode,
will appear.
© Select the timer position with the A/V buttons
and press the SET button.
• If the timer positions 1 to 4 have already been
set, the screen changes 2/2 (timer positions 5
to 8).
• Press the TIMER button (for VC-A410X) or the
G-CODE/TIMER button (for VC-H610X) to di 
rectly select the TIMER mode.
[Date]
DATE PR START STOP
IIMBI -- ----
DATE :DAY/M0NTH
SELECT :◄ ► CHANGE:A ▼
ENTER : SET EXIT sMENU
DATE PR START STOP
:| DAILY
SELECT :« ► CHANGE:A ▼
ENTER :SET EXIT : MENU
Numeric
buttons
or
A/V
Numeric
buttons
[Once]
* ►
. [Daily/Weekly]
* A/V > ►
[Channel]
DATE PR START STOP
15/12 EE " : ----- s --- SP
© Set the date for timer recording with the numeric
or A / ▼ buttons on the remote control and then
press the ► button.
• First set the “ day ” digits and then “ month ” . If
there is only one “ day ” or one “ month ” digit,
enter a 0 first.
Q If you want to record only once, press the
► button and go to step © Otherwise, select “ D
(DAILY) ” to record at the same time each day or
“ W (WEEKLY) ” to record at the same time each
week by pressing the A or ▼ button, and then
pressing the ► button.
0 Set the channel number using the numeric or A I
▼ buttons and then press the ► button.
I NOTE >
• To record audio and video from an external source
through an AUDIO/VIDEO terminal on the VCR, press the
A / ▼ buttons to select an AV channel. (When an AV
position is selected, “ L1 ” or “ L2 ” is displayed where a
channel position number is usually displayed.) (VC-A410X
is only equipped with AUDIO/VIDEO (rear) terminals.)
[ note ~> Continued on next page
• A /▼ buttons can also be used to set the date and time instead of the numeric buttons.
• Press 0 first if the day, month, hour or minute is a single digit.
25