Sharp VC-A410X

|f| New Sharp Super Picture __________ ______
This function creates clearer modulation during playback for high picture
quality.
S. PICTURE ON
Press the S. PICTURE button on the VCR.
“ S.PICTURE ON (or OFF) ” will appear on the TV screen for a few seconds.
Each time the button is pressed, the mode switches between ON and OFF.
(The New Sharp Super Picture is preset to ON at the factory.)
ON:
Normally leave the mode set to ON. This high picture quality function will
create a clearer image during playback.
OFF:
Set to OFF when playing back a tape on the VCR while editing or when strong noise
appears on the screen. Set to OFF when using the VCR as an editing source.
NOTE >
►This function only operates during playback. It will not
operate when recording or watching a TV programme
with the VCR tuner.
ra Zero-Back Function
• This function can not be set to ON/OFF with the MENU
screen displayed.
• If power is interrupted for more than 60 seconds
(power failure, etc.), the setting will return to ON.
The zero-back function makes the cassette fast forward (or rewind) to the previously set “ 0:00.00 ”
point and stop there.
Make sure the counter is displayed, then press the CLEAR button on the
remote control at the point you wish to return to later. “ 0:00.00 ” is dis 
played.
Press the ZERO BACK button on the remote control. The VCR
automatically detects the direction of the “ 0:00.00 ” position and fast
forwards (or rewinds) the tape.
When the tape reaches the “ 0:00.00 ” position, the tape automatically stops.
•The zero-back function does not operate during recording. The function works during the playback, stop, fast
forward, rewind and video search modes.
R DPSS (Digital Programme Search System)
With this feature you can quickly locate a desired section of the tape. The DPSS feature makes use of
VISS (index) signals to search for a specified tape segment and begin playback automatically.
VISS (Index) Signal
An VISS (index) signal is automatically recorded
on the tape at the start of ordinary recording,
simple recording timer and timer recording.
■► slow — © ------ ©
<3DPSS8>
O Load a tape containing VISS (index) signals into the VCR.
Q Select the VISS (index) number of the desired programme using the DPSS
or button on the remote control.
Search starts immediately. (When a signal is located, the displayed num 
ber decreases.)
© When the selected VISS (index) signal-encoded section is found, play 
back begins automatically.
NOTE >
► DPSS may not function properly if the VISS (index)
signals are too close together (within 3 minutes of
each other).
► DPSS can be cancelled by pressing the PLAY/X2 or
STOP button.
► If the tape reaches its end or is rewound completely
before locating the desired VISS (index) signal, DPSS
is cancelled.
• DPSS may not function for damaged or worn tapes.
• The DPSS function cannot be used with tapes that
contain no VISS (index) signals.
• The starting point of a programme may vary slightly.
• DPSS does not operate during the slow, record, timer
standby, and timer recording modes, or when there is
no cassette loaded.
29